void loop() digitalWrite(in1, HIGH); digitalWrite(in2, LOW); analogWrite(enA, 191); // 75% of 255
Since the manufacturer does not host a PDF, here is how you legally acquire the closest equivalent: hw 130 motor control shield for arduino datasheet free
The HW-130 Motor Control Shield is a versatile and easy-to-use accessory for Arduino enthusiasts. With its L298N motor control IC, PWM speed control, and built-in current protection, this shield provides a convenient and efficient way to control DC motors, stepper motors, and other high-power devices. By following the guidelines and resources provided in this article, you can get started with your HW-130 Motor Control Shield project today! delay(1000); // Run at full speed for 1
delay(1000); // Run at full speed for 1 second To use this shield
| Parameter | Value | |-----------|-------| | Driver Chip | L298N (or clone) | | Logic Voltage | 5V (from Arduino) | | Motor Drive Voltage | 5V – 12V DC | | Max Current per Channel | 2A continuous, 3A peak | | PWM Frequency | Up to 25 kHz (software controlled) | | PCB Size | ~68mm × 53mm |
// Stop digitalWrite(MOTOR_A_IA, LOW); digitalWrite(MOTOR_A_IB, LOW); delay(1000);
To use this shield, you must install the (Adafruit Motor Shield V1 library). Simple DC Motor Example: Controlling 12V DC Motors with L293D | PDF - Scribd